Angel Sent
Written by Trish
Things you will need...
Faith and Love Template by Dreamland Designs
(She has her templates on the right hand side... it's under 1-10)
Love Forever Scrapkit by Dreamland Designs or Scrapkit of Choice
You may buy a license to use his work at My PSP Tubes
Remember tutorials are just a guideline and creativity is always a must when doing PSP, so make it your own!!!
1. Open template
2. Delete the copyright layer
3. Pick a light and dark color from your tube for your color palette
4. Add a new raster layer
5. Go to Layers / Arrange / Send to Bottom
6. Flood fill this new layer with a gradient of your choosing using your 2 colors
7. Click on the layer called grey rectangle
8. Go to Selections / Select All
9. Go to Selections / Float
10. Go to Selections / Defloat
11. Pick a paper from the scrapkit
12. Copy and paste into selection
13. Delete
14. Go to Selections / None
15. Click on the layer called white frame 1
** Note **
You can leave the papers the same like I did or you can colorize them to match your tube if necessary
16. Click on the layer called thin grey rectangle 1
17. Merge thin rectangle 1 and 2 together
18. Do Steps 8 to 14
19. Click on the layer called white frame 2
20. Merge white frame 2 and 3 together
21. Click on the layer called thin grey rectangle 3
22. Do Steps 8 to 14
23. Click on the layer called circle
24. Do Steps 8 to 14
25. Click on the layer called grey frame
26. Go to Selections / Select All
27. Go to Selections / Float
28. Go to Selections / Defloat
29. Flood fill with white
30. Go to Selections / None
31. Click on the layer called frame fill
32. Do Steps 8 to 11
33. Go to Selections / Invert
34. Copy and paste as a new layer
35. Make sure that you are on your new layer and delete
** Do NOT deselect yet **
36. Add your tube
37. Duplicate two times so that you have 3 copies of your tube
38. Close off two of your copies
39. Place the open one in the far right square
40. Make sure that you are on your tube layer and delete
41. Close off that layer and open one of the other copies
42. Place this one in the middle square
43. Make sure that you are on your tube layer and delete
44. Close off that layer and open your last copy
45. Place this one in the far left square
46. Open all the tube layers
47. Add your main tube
48. Add any embellishments you would like to use
49. Add your copyright information and watermark
50. Add your text
Be sure to crop off any "dead space" around your tag, if necessary.
When you have your tag finished, save and you are done!!!
This tutorial is completely my creation and any similarity to any other tutorial is purely coincidental, unless otherwise stated above.
Any problems or questions, please email the Management
Home